Power Electronics Lab Assignment-XI: Simulation of Full Bridge Inverter
Power Electronics Lab Assignment-XI: Simulation of Full Bridge Inverter
Power Electronics Lab Assignment-XI: Simulation of Full Bridge Inverter
OBJECTIVE:
COMPONENTS REQUIRED:
MATLAB Simulink.
THEORY:
A single phase bridge DC-AC inverter is shown in figure.11.1. When the switches S1 and
S2 are turned on simultaneously for a duration 0 ≤ t ≤ T1, the input voltage Vs appears
across the load and the current flows from point ‘a’ to point ‘b’.
If the switches S3 and S4 turned on during T1 ≤ t ≤ T2, the voltage across the load is
reversed and the current through the load flows from point ‘b’ to point ‘a’.
CIRCUIT DIAGRAM:
SETTING UP SIMULATION:
4 R/C/L Simpower/Elements
5 Powergui Simpower
6 Voltage Simpower/Measurement
Measurement
7 Scope and Display Simulink/Sink
8 Pulse Generator Simulink/Sources
Table.11.1: Required Blocks and Their Location in Simulink Library.
Power Electronics Lab Assignment-XI
SIMULINK MODEL:
SCOPE OUTPUT:
Student Task:
1. Draw the waveforms of output voltage, current through each switch and output current with
R and RL load for a specific duty cycle.