13 - Ac121

General Performance Data
Prime Power 110KVA/88KW Brand Cummins

Engine
Stand by Power 121KVA/97KW Model 6BTA5.9-G2
Frequency/Speed 50Hz/1500rpm Control module Deepsea 6120
Rated Power Factor(cosφ) 0.8 Rated Current 166A
Standard Voltage 230V/400V Capacity of Breaker 225A
Phases 3 Starting Voltage DC24V
Fuel consumption Standards followed
Rated output Fuel consumption rate ISO9001 ISO14001
100%Standby 2 1 2 g/KW.h 3 0 L/h ISO8528 ISO12100
100%Prime 2 1 1 g/KW.h 2 7 L/h ISO13849 EN12601
75%Prime 2 1 2 g/KW.h 2 0 L/h GB12786 GB/T2820
50%Prime 2 1 9 g/KW.h 1 4 L/h IEC60034 IEC60204
25%Prime 2 4 8 g/KW.h 8 L/h CE RETIE
Dimensions and Weights
Type Open Silent
Length(mm) 2150 2950
Width(mm) 800 1100
Height(mm) 1450 1800
Weight(kg) 1200 1800
Base fuel tank volume (L) 210 210

Engine specification
Basic parameter Air induction system
Manufacturer dongfeng Cummins Maximum allowable intake air restriction
Model 6BTA5.9-G2 ---with clean filter element 3.7kPa
No. of cylinder 6 ---with dirty filter element 6.2kPa
Type 4 cycle, Vertical In-line Intake Air alarm temperature 82℃
Prime Power 106kw /142HP Exhaust system
Standby Power 116kw /155HP Max. allowable back pressure 10kPa
Turbocharged &
Induction system Standard exhaust pipe diameter 75mm
Aftercooled
Governor Electronic speed
Bore x Stroke 102x120mm Cooling system
Displacement 5.9L Coolant capacity
Compression ratio 17.3:1 ---Engine only 7.9L
Oil Capacity(Total) 16.4L ---Total system 23.8 L
Coolant Capacity(Engine only) 7.9L ---With heat exchanger 15.9L
Cranking Motor Voltage DC24V Standard thermostat(modulating) range 82-95 ℃
Fuel System Minimum cap pressure 69kPa
BYC Type A inline Max. allowable top tank temerature

Type Injection system 104/100 ℃
pump for stand by/prime power
Min. Allowable flow of fuel to
30 L/h
fuel pump
Lubrication system Electric system
Oil Pressure Min. recommended battery capacity (24V)
---Idle speed 207kPa ---10℃(50°F) & above- 0°F CCA 400
---Rated speed 345kPa --- 0℃(32°F) to 10℃(50°F)- 0°F CCA 400
Max. allowable oil temperature 121℃ ---18℃(0°F) to 0℃(32°F)- 0°F CCA 400
Offset sump oil capacity: low/high 14.2 /12.3L Max. allowable resistance of Starting circuit 0.002ohm
Total system capacity 16.4L Starter(heave,Anode) DC24V
Battery recharge system, negative ground 40ampere
Alternator specification
Phases 3 Coating Vacuum impregnation
Poles 4 Insulation class H
Power factor(cosφ) 0.8 Protection IP23
Winding connection Star Excitation system Self-excited
Winding pitch 2/3 Bearing Single Bearing
Voltage regulator type AVR Coupling Flexible disc

Control system Introduction
Deepsea 6120 Auto start & auto mains

Key Features:
failure control panel
Deepsea 6120 is an auto mains failure controller for single ● Auto start/stop, load transfer and alarming
generator, it can monitor and protect the generator of generator
working all the time. it has a LCD display which clearly ● Remote start on or off load
shows the status of the engine. this controller include ● With hierarchical loading function
seven inputs and six outputs. This controller can also be ● Multiple start/stop cycles can be preset
programmed using the front panel or by using DSE ● 3 phase generator and mains voltage monitoring.
configuration Suite PC software ● Generator/load power detection(kW, kVA, kVAr PF)
● Overload protection (kW)
①Emergency stop button ● Load current monitoring and protection

● Engine speed protection
⑤ ②Power switch
● Engine pre-heat
③Power indicator
● Engine start idle & stop idle
④Operation buttons
● Battery voltage monitoring
④ ③② ① ⑤LCD display ● Start under the low battery
● 4 active outputs
⑥ ⑦ ⑧
● 4 digital inputs and 3 analogue inputs.
● 6 Custom digital input
● 6 outputs(4 configurable on magnetic pick-up,
6 configurable on Canbus version)
● DSE2130,DSE2157,DSE2548 expansion module
can be connected
● Support 0-10V or 4-20mA oil pressure sensor
⑨ ⑩
⑥Voltage and frequency trimmer ⑨MCB

⑦Governor ⑩Relay
⑧Charger
Main features: Protection:
● Multi language display ● Two sets of protection parameters can be preset

● Mains failure self starting ● Normal alarm, electrical trip and shutdown alarm can be
● The running time of the engine can be recorded to set to effectively monitor the engine speed,oil pressure,
facilitate the maintenance and repair of the unit water temperature and oil level, as well as the frequency,
● User-friendly set-up and button layout voltage, current and power of the alternator, for
● LCD display can display multiple parameters at the complete engine/alternator protection
same time ● Low Oil Pressure
● Support EFI engine ● High water Temperature
● IP65 rating (with optional gasket) ● High voltage and low voltage
● PC and front panel configuration ● Overspeed
● 100 event records ● Emergency stop
● Data recording and trend analysis ● Fail to start
Decomposition diagram introduction of AOSIF Typical Canopy
Standard supply scope:
① Engine
⑧ ② AC Alternator
③ Cooling Radiator
④ Auto Start Control Panel
⑨ ⑤ Main Ciruit Breaker
⑥ Built in Shock Pad
⑦ High Strength Frame
⑩ ⑧ Exhaust silencer
⑨ Bellow
⑩ Starting battery
Optional supply scope:

Genset Engine Alternator Control system
● Tool box ● Fuel heater ● Temp. detector for ● ATS

● Base fuel tank ● Fuel and water winding and bearing ● Synchronization
● External daily fuel tank separator ● PMG System
● Trailer ● Antirust, mildew and ● Adjustable earth relay
salt fog treatment
● Anti condensation
heater
Breaker Fuel system Lub-oil system Cooling system
● ABB ● Low fuel level alarm ● Lub oil heater ● Elec.coolant Heater
● Schneider ● Auto Fuel Pump ● Temp.-sensor
● T Vlave ● Oil drain Pump
● AOSIF Engineering provides a full line of brand new and high quality products.
● Each unit passes strictly loading test in factory before shipment.
● Quality Warranty is provided strictly in accordance with warranty terms.
● Three level service guarantee: Aosif dealers, Service outlets of engine/alternator
manufacturers, Aosif service team.
严格按保修条款提供免费保修服务
XIAMEN AOSIF ENGINEERING LTD.

Marketing Center: Unit 1001,No.1 of Cheng Yi North Street,Software Park Phase III ,Xiamen ,China;
Factory: No.1088 Tangbian, Changtai Economic Development Zone, Zhangzhou,Fujian,China.
Website: www.aosif.com email：fannie@aosif.com.cn Mobile:008615880350205
You may get more information from our official account.

Specifications are subject to change without notice.

13 - Ac121

Uploaded by

Copyright:

Available Formats

13 - Ac121

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

13 - Ac121

Uploaded by

Copyright:

Available Formats

General Performance Data

Prime Power 110KVA/88KW Brand Cummins

Frequency/Speed 50Hz/1500rpm Control module Deepsea 6120

Rated Power Factor(cosφ) 0.8 Rated Current 166A

Standard Voltage 230V/400V Capacity of Breaker 225A

Phases 3 Starting Voltage DC24V

Fuel consumption Standards followed

Rated output Fuel consumption rate ISO9001 ISO14001

100%Standby 2 1 2 g/KW.h 3 0 L/h ISO8528 ISO12100

100%Prime 2 1 1 g/KW.h 2 7 L/h ISO13849 EN12601

75%Prime 2 1 2 g/KW.h 2 0 L/h GB12786 GB/T2820

50%Prime 2 1 9 g/KW.h 1 4 L/h IEC60034 IEC60204

25%Prime 2 4 8 g/KW.h 8 L/h CE RETIE

Dimensions and Weights

Type Open Silent

Length(mm) 2150 2950

Width(mm) 800 1100

Height(mm) 1450 1800

Weight(kg) 1200 1800

Base fuel tank volume (L) 210 210

Basic parameter Air induction system

Manufacturer dongfeng Cummins Maximum allowable intake air restriction

Model 6BTA5.9-G2 ---with clean filter element 3.7kPa

No. of cylinder 6 ---with dirty filter element 6.2kPa

Type 4 cycle, Vertical In-line Intake Air alarm temperature 82℃

Prime Power 106kw /142HP Exhaust system

Standby Power 116kw /155HP Max. allowable back pressure 10kPa

Governor Electronic speed

Bore x Stroke 102x120mm Cooling system

Displacement 5.9L Coolant capacity

Compression ratio 17.3:1 ---Engine only 7.9L

Oil Capacity(Total) 16.4L ---Total system 23.8 L

Coolant Capacity(Engine only) 7.9L ---With heat exchanger 15.9L

Cranking Motor Voltage DC24V Standard thermostat(modulating) range 82-95 ℃

Fuel System Minimum cap pressure 69kPa

BYC Type A inline Max. allowable top tank temerature

Lubrication system Electric system

Oil Pressure Min. recommended battery capacity (24V)

---Idle speed 207kPa ---10℃(50°F) & above- 0°F CCA 400

---Rated speed 345kPa --- 0℃(32°F) to 10℃(50°F)- 0°F CCA 400

Total system capacity 16.4L Starter(heave,Anode) DC24V

Battery recharge system, negative ground 40ampere

Poles 4 Insulation class H

Power factor(cosφ) 0.8 Protection IP23

Winding connection Star Excitation system Self-excited

Winding pitch 2/3 Bearing Single Bearing

Voltage regulator type AVR Coupling Flexible disc

Deepsea 6120 Auto start & auto mains

①Emergency stop button ● Load current monitoring and protection

⑥Voltage and frequency trimmer ⑨MCB

Main features: Protection:

● Multi language display ● Two sets of protection parameters can be preset

Standard supply scope:

Optional supply scope:

● Tool box ● Fuel heater ● Temp. detector for ● ATS

Breaker Fuel system Lub-oil system Cooling system

● Each unit passes strictly loading test in factory before shipment.

● Quality Warranty is provided strictly in accordance with warranty terms.

● Three level service guarantee: Aosif dealers, Service outlets of engine/alternator