Location via proxy:   [ UP ]  
[Report a bug]   [Manage cookies]                

Ec301 Digital Signal Processing, December 2023

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

Reg No.

: Name:
APJ ABDUL KA0ffl,Pq$€trft91&L9&lI u
B.Tech Degree 55 (S, FE) / $5 (PT) (S, FE) Examination December

Course Code: EC301


Course Name: DIGITAL SIGNAL PROCESSING
Max. Marks: 100 Duration: 3 Hours

PART A
' Answer any twofull questions, each carries 15 marks. Marks

I a) Compute the 4 point IDFT of X(k) - {1,0,1,0} (3)


b) Find the linearconvolution ofx(n): {1, 2, 1,2, l,Z, l,Z, 1,2,1 } and h(n) : {1,3,1} (g)
using overlap save method.
c) State and prove Parseval's theorem. (4)
2 a) Compute 8 point DFT using DIT FFT for the sequence x(n) = 2n ;0 I n 1 T (8)
b) Find 4 point DFT of the sequences xr(n): {4,3,1,5} and xz(n):{6,4,2,5} using (7)
single DFT.
3 a) Find 8 point DFT of the sequence x(n): {0,1,2,3,4,s,6,7} using radix-2 DIF-FFT (s)
algorithm.
b) Findthe linearconvolutionofx(n): {3, -1,0, 1,3, 2,0,1,2,11andh(n):{1, l, l} (7)
using overlap add method.

PART B
Answer any twofull questions, each carries IS morks.
4 a) Design a band pass filter to pass frequencies in the range I to 2 rad/sec using (7)
Hanning window with N=5
b) Explain the procedure for designing FIR fi-lters using frequency sampling method.. (5)
c) Write any three comparisons between the design methods used for Linear Phase FIR (3)
Filters
5 a) Design an analog Butterworth filter for the given specification (6)
0.9<lH(/o)l <1 for 0<o<0.2n
lH0fo)l < 0.2 for 0.4n<O<z

Page 1 of 2
060008c301012302
.l
b) D.qsign a Butterworth low pass digital IIR filter with a pass band edge frequency of (9)
0.252 with a ripple not exceeding 0.5d8 and a minimum stop band aftenuation l5dB
with a stop band edge frequency of 0.552. Use bilinear transformation.
6 a) An analog filter has a transfer function Ha(s) = Design a digital filter (7)
Gffi.
equivalent to this using impulse invariant method. Assume T:l sec
b) The desired frequency response ofa LpF is (S)
( -,..
Ha(a') = ; lool < 3n4
- l"-"'
(0 ; otherwise
Determine filter coefficients for N=7 using hamming window.

PART C
Answer ony twofull questions, each carries 20 marks.
7 a) Obtain the direct form I, direct form II, cascade and parallel form realization for (20)
the system with transfer function

H(z)' =l:1:" -:.* ?9--:


L+0.12-t-0.22-2
8 a) Obtain the expression for the output y(n) when an input sequence x(n) is first applied (5)
to an interpolator with upsampling factol L:5 , then to a decimator with a
downsampling factor M:10 and again upsampled by afactor L:2.
b) Explain finite word length effects in IIR digital filter (10)
c) Differentiate fixed point and floating point arithmetic. (5)
9 a) Draw the architectural block diagram of TMS320C67XX DSP processor and (10)
explain each block.
b) Explain the effect in the spectrum of a signal x(n) when it is (5)
(i) Decimated by
. a factor 2

2
(ii) Interpolated by a factor '-;,
c) .Explain round off errors (5)
rt* **

Page 2 of 2

You might also like